Homepage of Kaimei copper elongation

　I am doing work to maintain a die after aluminum pushing out.

 

I sell an angle and a channel, a flat bar, a corner pipe, a circle pipe, the dies of various shapes including the variant.

 

There is work called the caustic work to remove aluminum after pushing out in work. The work becomes the problem by the work that a burden depends on physically.

　

Such a work of the burden was caustic waste fluid processing most in that.

 

I lifted heavy, hot waste fluid on the top and was doing work dangerous at all to be connected for a medicine burn and an injury, an accident as I threw it away.

 

　So what I hit on absorbs waste fluid with a pump, and should I throw it away? It means.

 

However, problems that there was not a place to throw away waste fluid again where a pump was not able to bear temperature of the heat to suck waste fluid have been produced.

 

Therefore when even a high temperature checked whether there was not a tolerable pump, there was it, but a price was readily high, and the approval of the boss was in condition not to go down.

 

　It places waste fluid temporarily to have thought next and should not lower temperature, or it means.

 

I thought that I could smoke even a common pump if temperature fell.

 

However, as I did not know how I should check whether temperature fell, I talked with the boss and concluded that I used the temperature stick.

 

The problem of the temperature and the problem of the pump were solved, but a problem what you did for came out to placing waste fluid temporarily.

 

Therefore I establish the waste fluid place, and should I lower temperature? I hit on this. In consultation with the boss, I had you purchase a waste fluid case.

 

　Then, it became the problem how I should suck it with a pump to *ekisute teno tank. When it is a hose, I act violently,

 

A medicine acted violently and thought that it was dangerous. Therefore I had the cooperation of the boss, and it was revealed that you attached a hose there and should drain it using a pipe.

 

It turned out that I could easily do waste fluid processing by letting a pipe go through.

 

　However, it turned out that you must empty a hole into the wall to let a pipe go through and was disappointed.

 

As a manager told you "to empty a hole into the wall using an electric drill" when worried about what I should do, I was able to put it.

 

Caustic waste fluid processing came to be thereby possible.

 

However, an injury has occurred later for several years.

 

What I thought of there having been lacking in maintenance.

 

I borrow the cooperation of the facilities section and am favorable in the state that any problem does not happen now. It was shortened the waste fluid processing time of approximately 30 minutes by this result improvement.

 

[after the improvement]